1 / 5
PFRM-0-2075
Workshop Machinery · Workshop presses
SCOTT HP-75 Workshop Hydraulic Frame Press
Hand hydraulic with pneumatic assistance Moveable sliding cylinder
$4,299.00
Excludes GST. Configuration and freight quoted with your enquiry.
NZ Prepared, installed and supported nationwide by Scott Machinery.
Model
HP-75
Capacity
75 Ton
Ram stroke
250mm
Ram diameter
93mm
NZ owned
Since 1989
Industry people
Practical machine advice
Auckland + Christchurch
Two support hubs
Nationwide support
Installation, training & service
Parts & accessories
Large local range
Product overview
About this machine.
Hand hydraulic with pneumatic assistance Moveable sliding cylinder
Hand hydraulic pump
- Pneumatic assistance with foot valve
- Moveable sliding cylinder L/R
- Table lift winch
- Vee block set
- Pressure gauge
- ** 60 psi line pressure is all that is required to achieve the max. Pressure of 75 ton on this workshop press and the regulator is pre-set to allow this**
Published data
Specifications
Use these to shortlist. We’ll confirm the specification and configuration against the application.
Model
HP-75
Capacity
75 Ton
Ram stroke
250mm
Ram diameter
93mm
Working range
68 - 884mm
Table width
279mm
Distance between frames
800mm
Floor Dimensions
1450mm w x 1940mm h
Packaged dimensions
1100mm x 1200mm x 2110mm
Nett machine weight
451 kg
Gross weight
497 kg
Talk to Scott Machinery
Is this the right machine for your work?
Tell us about the largest job, material and likely workload. We can confirm the fit — or point you to the model either side.
Auckland · Christchurch · Nationwide support