Luxcut 6128 x 700 & DM20VS Combination Lathe & Mill, Single Phase
$3,740.00
Product Description
Available as a combined unit or seperate machines.- Lathe
- Belt change speed control
- 26mm / 1" spindle bore
- Enclosed feed box
- Induction hardened bedway
- Right hand carriage wheel
- Cabinet stand
- 125mm 3 Jaw chuck
- 125mm 4 Jaw chuck
- Rear splash guard
- Toolbox
- Mill
- Variable speed via potentiometer
- Digital RPM display
- Lathe mounted
- High / Low gear range
- Dovetail column
- Digital display on quill mm/inch
- Head can tilt +/- 90 degrees
- Control panel on arm
- Fwd/rev spindle direction switch
- 13mm Keyed drill chuck & arbor
Specifications
| Luxcut | 6128 x 700 Lathe |
| Swing over bed | 280mm |
| Swing over carriage | 175mm |
| Distance between centers | 700mm |
| Spindle bore | 26mm |
| Spindle speeds | 150 - 2000 rpm (6 Steps) |
| Thread range | 0.2-3.5mm (18 kinds) / 8-56 TPI (21 kinds) |
| Tailstock taper | 2MT |
| Motor | 850w 1 Phase |
| Luxcut | DM20VS Mill Drill |
| Drilling capacity | 20mm |
| Facing capacity | 50mm |
| Spindle to carriage | 365mm |
| Spindle taper | 2MT |
| Spindle speeds | 50 - 3,000 rpm 2 ranges infinitly variable |
| Motor | 850w 1 Phase |
